gnome-nettool

This is a discussion about gnome-nettool in the Everything Linux category; gnome-nettool shows incorrect State of the interface. The eth0 interface is up and I'm able to send and receive the packets. BUT the 'gnome-nettool-1. 4. 1' shows incorrect STATE of the interface. It shows it as 'Inactive'.

Everything Linux 1798 This topic was started by , . Last reply by ,


data/avatar/default/avatar18.webp

1 Posts
Location -
Joined 2006-06-22
gnome-nettool shows incorrect "State" of the interface.
 
The eth0 interface is up and I'm able to send and
receive the packets. BUT the 'gnome-nettool-1.4.1'
shows incorrect "STATE" of the interface. It shows it
as 'Inactive'. The hardware address is also shown
incorrectly. It displays the address as
"70:00:00:00:00:00".
 
I tried it with GNOME Nettool 2.14.2 but doesn't seem
to be working fine. I'm using SUSE Linux 10.
 
Any suggestions??

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This subject has been archived. New comments and votes cannot be submitted.
Jun 22
Created
Jun 22
Last Response
0
Likes
<1 minute
Read Time
User
Users