scsi scanner not detecting
This is a discussion about scsi scanner not detecting in the Linux Hardware category; okay, i'm using an AHA 2940AU scsi adapter and that is apparently supported. unfortunately it wont pick up the scanner i am trying to get to work. its a HP 6100c. what is going on? i'm pulling my hair out.
okay, i'm using an AHA 2940AU scsi adapter and that is apparently supported. unfortunately it wont pick up the scanner i am trying to get to work. its a HP 6100c.
what is going on? i'm pulling my hair out. i've tried modprobing every scsi port i can find. anyone got any ideas?
what is going on? i'm pulling my hair out. i've tried modprobing every scsi port i can find. anyone got any ideas?
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
May 26
May 28
0
1 minute
Responses to this topic
Since no one has responded yet, I will give this a try.
What Linux distro and version do you have? Kernel versions less than 2.4.20 apparently had a conflict with ide-scsi, so this may be an issue.
Do you have sane installed on the system?
I assume that you tried modprobe sg and have no output for the scanner when looking at dmesg?
What does lsmod show?
What Linux distro and version do you have? Kernel versions less than 2.4.20 apparently had a conflict with ide-scsi, so this may be an issue.
Do you have sane installed on the system?
I assume that you tried modprobe sg and have no output for the scanner when looking at dmesg?
What does lsmod show?
You need Linux kernal V 2.2.19 or later which I assume you have.
For information, go to " http://www.kirchgessner.net/sanehpfaq.html#HPFAQ0AB ".
