Bell Sympatico problem with RedHat9.0
This is a discussion about Bell Sympatico problem with RedHat9.0 in the Linux Networking category; I am using Bell Sympatico high speen internet under RedHat9. 0. When I am connected to the internet, my connectiion automatically goies off and then comes in. I used the pppoe that came with RedHat9.
I am using Bell Sympatico high speen internet under RedHat9.0. When I am connected to the internet, my connectiion automatically goies off and then comes in. I used the pppoe that came with RedHat9.0. As root, /sbin/adsl-setup is used to configure internet connection. Everything is fine and simple. I gave user control "yes" during setup. However, everytime I have to pass /sbin/adsl-start as root. If I do that as user, nothing happens. My NIC is configured to get IP from dhcp during boot. It causes delay during boot time and fails to get IP. That's reasonable, I think. However, what should be the correct configuratioin for the NIC. I tried with static private IP but then I do not know the DNS.
Would be very much happy if some one can give a solution.j sleep ?
Would be very much happy if some one can give a solution.j sleep ?
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Jul 17
Jul 18
0
2 minutes
Responses to this topic
Hi there,
For your sympatico high speed internet ,first you have to assign your eth0 a fake ip like 10.0.0.1 and netmask 255.255.255.0 rather than getting your ip by DHCP by running redhat-config-network this can bring up your interface eth0 quickly at boot time. After your system boot up run adsl-start , and find out your nameserver's ip from your /var/log/messages file and put those two DNS address into /etc/resolv.conf . e.g nameserver x.x.x.x.
To run your sympatico internet connection at boot time just make afile with any name like sympatico with the commands given below
#!/bin/bash
adsl-start
sleep 3
ifconfig eth0 mtu 1480
and add the file into your /etc/rc.d/rc.local file with full path. Don't forget to change the mode of file to executable.
I hope you know about little changes in your /etc/ppp/pppoe.conf and pap-secrets for your sympatico id and password.
Enjoy,
crazy vkumar crazy
For your sympatico high speed internet ,first you have to assign your eth0 a fake ip like 10.0.0.1 and netmask 255.255.255.0 rather than getting your ip by DHCP by running redhat-config-network this can bring up your interface eth0 quickly at boot time. After your system boot up run adsl-start , and find out your nameserver's ip from your /var/log/messages file and put those two DNS address into /etc/resolv.conf . e.g nameserver x.x.x.x.
To run your sympatico internet connection at boot time just make afile with any name like sympatico with the commands given below
#!/bin/bash
adsl-start
sleep 3
ifconfig eth0 mtu 1480
and add the file into your /etc/rc.d/rc.local file with full path. Don't forget to change the mode of file to executable.
I hope you know about little changes in your /etc/ppp/pppoe.conf and pap-secrets for your sympatico id and password.
Enjoy,
crazy vkumar crazy
